Engineering Drawing For RRB ALP/TECHNICIAN CBT2 || Engineering Drawing Scale

Spread the love

Engineering Drawing For RRB ALP/TECHNICIAN CBT2 || Engineering Drawing Scale

Engineering Drawing For RRB ALP/TECHNICIAN CBT2, Engineering drawing for rrb alp cbt2 exam, basic engineering drawing mcq, engineering drawing for assistant loco pilot cbt2 exam, Engineering drawing fundamental questions. engineering drawing objective questions for rrb alp cbt 2 exam, engineering drawing scale, engineering drawing scale notes, engineering drawing scale pdf

Engineering Drawing For RRB ALP/TECHNICIAN CBT2

engineering drawing scale

Engineering Drawing For RRB ALP/TECHNICIAN CBT2

Welcome to your Engineering drawing scale

1. Which one of the following is not a reduction scale?
2. For drawing of small instruments, watches etc. the scale used is
3. When the drawing are drawn smaller than the actual size of object then scale is known as
4. If the 10m length is represented as 1 mm on the map then representative fraction is
5. The R.F. of scale is always
6. The unit of Representative fraction (R.F)is
7. The full form of R.F. is
8. A map of 10 cm X 8 cm represents an area of 50000sq. meter of a field. The R.F. of the scale is
9. An area of 36 square kilometer is represented by 144 square centimeter on a map. What is the R.F. ?
10. When measurements are required in three consecutive units, the appropriated scale is
11. In the diagonal scale, the word “diagonal” is used because it is most suitable for the measurement of
12. For scale, which one is not correct
13. When 1cm on a map represents 10m on the ground, the representative fraction of the scale is

Click Here For Introduction of Engineering Drawing Questions 
Click Here for Part B (Physics & Math) Quiz 

Leave a Reply